Login or Register for FREE!
Subelement A

RADAR Principles

Section 10

Circuits-2

In the circuit shown in Fig. 8A4, U5 pins 1 and 4 are high and both are in the reset state. Assume one clock cycle occurs of Clk A followed by one cycle of Clk B. What are the output states of the two D-type flip flops?

  • Pin 5 low, Pin 9 low.
  • Pin 5 high, Pin 9 low.
  • Pin 5 low, Pin 9 high.
  • Correct Answer
    Pin 5 high, Pin 9 high.
This question does not yet have an explanation! Register to add one

Tags: none

If more light strikes the photodiode in Fig. 8A5, there will be:

  • Less diode current.
  • No change in diode current.
  • Correct Answer
    More diode current.
  • There is wrong polarity on the diode.
This question does not yet have an explanation! Register to add one

Tags: none

In the circuit shown in Fig. 8A6, which of the following is true?

  • With A and B high, Q1 is saturated and Q2 is off.
  • Correct Answer
    With either A or B low, Q1 is saturated and Q2 is off.
  • With A and B low, Q2 is on and Q4 is off.
  • With either A or B low, Q1 is off and Q2 is on.
This question does not yet have an explanation! Register to add one

Tags: none

What is the correct value of RS in Fig. 8A7, if the voltage across the LED is 1.9 Volts with 5 Volts applied and If max equals 40 milliamps?

  • 4,700 ohms.
  • 155 ohms.
  • Correct Answer
    77 ohms.
  • 10,000 ohms.
This question does not yet have an explanation! Register to add one

Tags: none

The block diagram of a typical RADAR system microprocessor is shown in Fig. 8A2. Choose the most correct statement regarding this system.

  • The ALU is used for address decoding.
  • General registers are used for arithmetic manipulations.
  • The control unit executes arithmetic manipulations.
  • Correct Answer
    Address pointers are contained in the general registers.
This question does not yet have an explanation! Register to add one

Tags: none

You are troubleshooting a component on a printed circuit board in a RADAR system while referencing the Truth Table in Fig. 8A8. What kind of integrated circuit is the component?

  • Correct Answer
    D-type Flip-Flop, 3-State, Inverting.
  • Q-type Flip-Flop, Non-Inverting.
  • Q-type Directional Shift Register, Dual.
  • D to Q Convertor, 2-State.
This question does not yet have an explanation! Register to add one

Tags: none

Go to 9 Go to 11