In LSB (Lower Side Band) emissions, the transmitted energy falls below the suppressed carrier frequency. Transmitting with a display frequency of 18.068 MHz puts the emissions outside of the allowed band of 18.068 to 18.110 MHz. The emitted energy falls within the band for all other answers.
Last edited by kb7m. Register to edit
Tags: none
Test Tip: With all of these types of questions the correct answer begins with "3 kHz"
The SSB take up approximately 3khz of bandwidth for Lower Side Band (LSB) so you need to tune the radio 3khz above the lower edge so you will not be transmitting outside of your bandwidth privileges.
Last edited by mrdfox7. Register to edit
Tags: phone ssb bandwidth arrl chapter 3 arrl module 3a
In USB (Upper Side Band) emissions, the transmitted energy falls above the suppressed carrier frequency. Transmitting with a display frequency above 14.149 MHz puts the 1KHz bandwidth emissions outside the top of the allowed band at 14.15 MHz. The emitted energy falls within the band for all other answers.
For safety you may want to keep your carrier frequency below 14.147 in case your AFSK audio exceeds a bandwidth of 1 KHz because the USB bandwidth could be as much as 3 KHz.
Last edited by kb7m. Register to edit
Tags: none
Remember that your actual signal extends to either side of the frequency you are transmitting on. A Single Side Band (SSB) transmission is considered to have 3 kHz of bandwidth below the carrier, so you should set your carrier at least 3 kHz higher than the lower edge of the 80 meter band's voice portion when operating LSB.
The lower limit for phone in the 3MHz (80 meter) band is 3.600 MHz, so the sidebands of your signal if you transmit on 3.601 Mhz could easily go below 3.600 MHz and you would be transmitting in a part of the band where phone is not allowed.
Last edited by w6dxn. Register to edit
Tags: international morse code bandwidth 75/80 meters arrl chapter 3 arrl module 3a
The 60 meter band has special restrictions including the restriction of radiated power relative to the gain of a half-wavelength dipole antenna which is 100 watts PEP. If the antenna is something other than a half-wavelength antenna, then the power output must be adjusted.
If you have a 3 dBd gain antenna which would be twice the gain of a dipole, then you would have to reduce the output power to 50 watts.
brankin
Hint: The only answer has "half-wave dipole" in it.
-KE0IPR
Last edited by wileyj2956. Register to edit
Tags: 60 meters transmit power rules and regulations arrl chapter 3 arrl module 3a
All signals transmitted by an amateur on 60 meter channels must be centered within the channel.
-brankin
Memory Aid: Think "sixty-center"
-KE0IPR
Last edited by ke0ipr. Register to edit
Tags: arrl chapter 3 arrl module 3a
This is a memory item.
See http://www.arrl.org/images/view//Charts/Band_Chart_Image_for_ARRL_Web.jpg
Last edited by kb7m. Register to edit
Tags: none
Message forwarding systems are just that -- systems that forward messages.
While control operators of message forwarding stations are expected to do what is reasonable to prevent incorrect use of their station, the primary responsibility for the contents of a message still belongs to the station that sends the original message.
Last edited by schubie1. Register to edit
Tags: control operator rules and regulations message forwarding arrl chapter 3 arrl module 3a
Primary responsibility for the contents of a message belongs to the originating station but your station still has the responsibility to do what is reasonable to ensure that the transmissions that it sends (including forwarded messages) do not violate FCC rules.
Basically that just means that if you discover that your station is forwarding something that violates rules, take steps so that that communication is no longer being forwarded.
Last edited by kd7bbc. Register to edit
Tags: digital modes rules and regulations message forwarding arrl chapter 3 arrl module 3a
Just remember that on a ship or plane the captain is in charge =] That could be the captain/master of a seagoing vessel or the captain/pilot of an airplane. In either case you should not use an amateur radio station without permission from the captain.
Last edited by kd7bbc. Register to edit
Tags: aircraft/ship operation station types arrl chapter 3 arrl module 3a
Amateur Radio stations aboard a US-registered vessel in international waters are under the same guidelines as any station on US soil. You need a FCC-issued ham license or a reciprocal permit for an alien amateur license (meaning a license from another country) to operate your license on US soil, so you need that on a US-registered vessel as well.
Last edited by mvs90. Register to edit
Tags: aircraft/ship operation international arrl chapter 3 arrl module 3a
Slow scan TV uses a similar amount of bandwidth to SSB phone (voice) transmissions, so it is allowed on the same band segments (except 60 meters).
Last edited by gxti. Register to edit
Tags: arrl chapter 8 arrl module 8e
The rules for operating an amateur radio station aboard a vessel or craft in the US are roughly the same as the rules governing any other station in the United States.
Specifically, the control operator (the person in physical control of the station apparatus) must either hold a valid FCC-issued amateur radio license or they must be authorized for alien reciprocal operation -- that is, they can operate if they are an alien (non-US citizen) holding a license in a country with whom the US has a reciprocal operating agreement allowing them to operate in the United States with their alien amateur radio license.
Last edited by kd7bbc. Register to edit
Tags: aircraft/ship operation station types arrl chapter 3 arrl module 3a
This is a memory item.
See http://www.arrl.org/images/view//Charts/Band_Chart_Image_for_ARRL_Web.jpg
Last edited by kb7m. Register to edit
Tags: none